[IPM-4220/ IPM-8220] How to control power via the console port of theat IPM-4220/ IPM-8220?

The console cable is not included in the package. You need to buy this cable. The RJ45-to-DB9 cable is needed in order to connect with the computer COM port. The pins of the RJ45-to-DB9 cable are corresponding to different parts as described below:

9-pin D-sub female connector                        RJ45 connector

Step 1. Connect to PC and COM port 1 via the console cable.

Step 2. Go to Computer management and check whether Switched IPM is detected.

Step 3. Go to Serial port è Switch Kind of Serial Port 1 to Console.

Note: Check whether the data rate and the other setting are the same with PC.

Step 4. Open and set the console tool to PuTTY.

Step 5. Enter the account and password that are used to log in the main menu of Switched IPM.