FAQs

Solution:
Yes, please refer to Appendix B 802.1Q VLAN Setting example from GSW-4804SF user's manual for reference.

To reset the IP address to the default IP Address "192.168.0.100" or reset the login account and password to default value, please refer to following procedure.
1. Press the hardware reset button at the front panel about 5 seconds.

2. After the device is rebooted, you can login the management Web interface within the same subnet of 192.168.0.xx.
3. Factory-default IP Address and username / password are shown as following:
Default IP address: 192.168.0.100
Default User Name: admin
Default Password: admin
In the reset to default steps above, this SGSD-1022 as the example. However, the step for SGSW-2840 series is the same.

[Answer]
Certainly, the option is DHCP Relay Configuration page on WEB UI. It is named “Relay Information Mode”.

The IP Stacking technology of PLANET SGSD-1022 series and SGSW-2840 series switch also called Switch Clustering – Clustering allows up to 36 switches to be grouped together for centralized management through a single unit and one single IP address. Switches can be included in a cluster regardless of physical location or switch type, as long as they support clustering and are connected to the same local network.

yes. The GSD-805 supports 9K Jumbo frame.

yes, due to each RJ-45 port of GSD-805 support Auto negotiation and it can run at not only 1000Mbps full-duplex but also 10/100Mbps half / full-duplex mode.

GSD-805 is an eight port Gigabit Ethernet Switch, all its RJ-45 port support triple speed, i.e. 10Mbps, 100Mbps or 1000Mbps.
And FSD-805 is an eight port Fast Ethernet Switch where only runs at 10Mbps, 100Mbps each port.

However, both switches are all with built-in universal internal power, both of them is a palm sized Ethernet Switch.