FAQs

A: Solution:
The WGSD-10020 supports SFP type auto-detection. However, some of the SFP transceiver can not report the type information at the moment of plug into the slot. As a result, WGSD-10020 could encounter the detection / synchronization issue and can not runs smoothly.
In such circumstance, we would suggest to pre-setup the port(s) that is going to attach 100Base-FX SFP transceiver to 100 Force mode in the Web page (as figure below), that shall make the connection error free.

At temperature 0 ~ 40 Degrees C range, FNSW-1600P PoE output can achieve 100%. Due to the PSU hardware design, if the temperature arises up to 50 Degree C, it will reduce 20% of Power Budget and higher temperature will reduce the total output power as a result.

At temperature 0 ~ 40 degrees C range, FNSW-2400PS PoE output can achieve 100%. Due to the PSU hardware design, if the temperature arises up to 50 Degree C, it will reduce 20% of Power Budget and higher temperature will reduce the total output power as a result.

Solution:
The WGSD-10020 / WGSD-10020HP support SFP type auto-detection. However, some of the SFP transceiver can not report the type information at the moment of plug into the slot. As a result, WGSD-10020 / WGSD-10020HP could encounter the detection / synchronization issue and can not runs smoothly.
In such circumstance, we would suggest to pre-setup the port(s) that is going to attach 100Base-FX SFP transceiver to 100 Force mode in the Web page (as figure below), that shall make the connection error free.

Solution:
The Over Temperature Protection of the PoE Switch offers a safety and stable PoE operating by limit the output power according to detected temperature to prevent destructive breakdown due to un-expected overheating.
The over temperature protect function is enable and PoE chipset’s temperature is over 80 Degree C. The maximum PoE budge is reduced to 140 Watts.
The over temperature protect function is enable and PoE chipset’s temperature is over 83 Degree C. The maximum PoE budge is reduced to 130 Watts.

[Answer]
Certainly, the PLANET MGSW-24160F supports SSL and SSH both. However, they are disabled with default setting. You could enable them what you want. The HTTPS (SSL) and SSH location are under “Security” option on the WEB UI menu.

As CLI command, please refer to follow example.
SWITCH/>security switch https mode enable
SWITCH/>security switch https mode disable
SWITCH/>security switch ssh mode enable
SWITCH/>security switch ssh mode disable

[Answer]
Certainly, the option is DHCP Relay Configuration page on WEB UI. It is named “Relay Information Mode”.