FAQs

The GSW-1602SF and GSW-2404SF (Version 1, 2 and 3) do not support Spanning Tree over Link Aggregation function.

No, the FGSW-2620 does not support Jumbo Frame.

At temperature 0 ~ 40 degrees C range, FNSW-2400PS PoE output can achieve 100%. Due to the PSU hardware design, if the temperature arises up to 50 Degree C, it will reduce 20% of Power Budget and higher temperature will reduce the total output power as a result.

The GSW-1600HP is designed with over power loading protection functions. Please make sure that your total PoE output is within 220Watts. If your PD device is the IEEE 802.3at (standard) and it needs 24Watts for powering up, the GSW-1600HP only can power up to 9 of your PD devices.

1.Remote full management solution.
2.Increase more IEEE 802.1Q VLAN group (from 26 to 256).
3.SSL / MAC address limit / filtering, source IP-MAC / port-binding function
　enhances.
4.Remote Telnet management function enhances.
5.Support SNMPv3 and 4 RMON groups.
6.Configuration backup / restore function enhances.
7.Add Web firmware upgrade method.

A: Solution:
The WGSD-10020 supports SFP type auto-detection. However, some of the SFP transceiver can not report the type information at the moment of plug into the slot. As a result, WGSD-10020 could encounter the detection / synchronization issue and can not runs smoothly.
In such circumstance, we would suggest to pre-setup the port(s) that is going to attach 100Base-FX SFP transceiver to 100 Force mode in the Web page (as figure below), that shall make the connection error free.

1. Different Flash component used.
2. Different firmware structure and management functions.
3. Due to the differences, the firmware is incompatible between version 1 and version 2.