FAQs

A: Solution:
The WGSD-10020 supports SFP type auto-detection. However, some of the SFP transceiver can not report the type information at the moment of plug into the slot. As a result, WGSD-10020 could encounter the detection / synchronization issue and can not runs smoothly.
In such circumstance, we would suggest to pre-setup the port(s) that is going to attach 100Base-FX SFP transceiver to 100 Force mode in the Web page (as figure below), that shall make the connection error free.

At temperature 0 ~ 40 Degrees C range, FNSW-1600P PoE output can achieve 100%. Due to the PSU hardware design, if the temperature arises up to 50 Degree C, it will reduce 20% of Power Budget and higher temperature will reduce the total output power as a result.

The FGSW-2620 Gigabit Switch provided high performance 24-Port 10/100Mbps + 2 10/100/1000Mbps Ethernet port. The extra two Gigabit ports make FGSW-2620 to be a Gigabit back bone Switch in Gigabit Network. For example, you can attach PC workstation groups to 10/100Mbps port and then attach Storage Server (such as NAS Server) to one of Gigabit port, finally use another Gigabit port connect to Gigabit back bone Network.

1.Remote full management solution.
2.Increase more IEEE 802.1Q VLAN group (from 26 to 256).
3.SSL / MAC address limit / filtering, source IP-MAC / port-binding function
　enhances.
4.Remote Telnet management function enhances.
5.Support SNMPv3 and 4 RMON groups.
6.Configuration backup / restore function enhances.
7.Add Web firmware upgrade method.

Different operate temperature.

Please refer to the table below:

Please refer to the table below: