FAQs

Please refer to the following steps to set the Power Schedule On/Off.
Step 1. Go to “Time Setting” to confirm a time in the Time Sync Frequency.

Step 2. Go to “Schedule On/Off” to set the power to Off.

Step 3. Go to “Schedule On/Off” to set the power to On.

Step 4. Save the setting.

Step 5. Done

You can set it through web page or adjust hardware jumper on motherboard. Web page:
1. Go to Admin Home page.
2. Select Server Settings.
3. Select Shutdown of sub menu.
4. Enable "Reset configuration to factory default".
5. Click "Reboot" button for completing the process.

SmartSync does not use CIFS/SMB, FTP or NFS as its communication protocol. It is based on SSL over TCP/IP. This also means SmartSync has its own security policy and won't refer to SMB, FTP or NFS security setting.

You can follow the steps below to set up email event:
1. Go to NAS-7410 Admin Home page and select "Network Settings".
2. Select the sub menu "Email".
3. Enable SMTP Protocol.
4. Fill in correct SMTP server IP address or Fully Qualified Domain Name (FQDN). (*If you fill in FQDN, please make sure you have set DNS server IP address inside NAS-7410.)
5. Fill in a legal user account for login SMTP server purpose.
6. Based on your need, fill in one or two Email Addresses.
7. Click "Apply" and then select "Event" menu to configure further settings.
8. Click "Advance" button in "Configuration" sub menu of "Event".
9. Enable "Email Alert".
10. Check "Event List for Notification" to decide which events can be sent to administrator via email.
11. Click "Apply" button to complete settings.

We suggest user to use the same screen resolution to set video wall so that user can get the best performance.

Please refer the steps below:

1. Connect the IR emitter cable to IHD-410PT, and make IR emitter cable focus to video source device.
   
2. Connect the IR receiver cable to IHD-410PR.
   
3. Power on IHD-410PT and IHD-410PR.
   
4. Make them connect to each other.
   
5. Use the remote controller of video source device to control video source device via IR receiver cable.

By default, the Video Mode is selected.

Graphic Mode: It’s usually for the static state video. Pictures are the main display contents, and the pixel update processing is not so fast. The CPU consumption is lower than video mode.

Video Mode: It’s usually for the dynamic state video. Videos are the main display contents, and the pixel update processing is fast. The CPU consumption is higher than graphic mode.