FAQs

Execute the “IPM1200x Upgrade tool” program which can be found on the included CD-ROM, specify the IPM device and input the admin password (to obtain the upgrade access right) and then open the firmware file .bin to execute the upgrade.

You can use two or more ports of HDMI splitter to connect.

1. If you don’t use Safari browser, please download BonjourSDKSetup on PC.
　 You could download on Internet for free (IE browser is not recommended.).
2. Make sure to choose the right firmware on the right unit (click on the right Web UI).
3. Do not interrupt while updating.
4. You should update each unit to make there are all using the same firmware for optimal performance (eg, if there are 3 Rx, youshould update for 3 times.).

Please refer the steps below:

1. Connect the IR emitter cable to IHD-410PT, and make IR emitter cable focus to video source device.
   
2. Connect the IR receiver cable to IHD-410PR.
   
3. Power on IHD-410PT and IHD-410PR.
   
4. Make them connect to each other.
   
5. Use the remote controller of video source device to control video source device via IR receiver cable.

Regarding this detail description, it is suggested to download the product FAQ: ftp://ftp.planet.com.tw/FAQ/Network Peripheral and read the documention for more understandings, thank you!

Make sure the jumper is set to Master (for 3.5" IDE drives) and format the HDD using the FAT32 file system before installing it.

Make sure you have saved the new settings, then exit the Setup menu and restart the DSP-1000 by turn off the power switch. Turn it on few seconds later to make the setting take effect..