FAQs

Regarding this detail descriptions, it is suggested to download the product FAQ: ftp://ftp.planet.com.tw/Network Peripheral and read the documentation for more understandings, thank you.

With DHCP Server
1)Install the IPM-1200x after DHCP server.
2)Set the IP of PC to “Obtain an IP address automatically”.
3)Power ON the IPM-1200x.
4)Open IPM1200x Upgrade tool to search the IPM-1200x.
　Not with DHCP Server
1)Power ON the IPM-1200x
2)Open the HyperTeminal to disable the BOOTP/DHCP Control via console port.

3)Set the static IP HyperTeminal.

4)Select the “Use the following IP address” and Set the static IP to PC.
5)Open IPM1200x Upgrade tool to search the IPM-1200x.

Execute the “IPM1200x Upgrade tool” program which can be found on the included CD-ROM, specify the IPM device and input the admin password (to obtain the upgrade access right) and then open the firmware file .bin to execute the upgrade.

You can use two or more ports of HDMI splitter to connect.

Video Wall：8 x 8.

Video Extender：Theoretically, 1000 are the most as long as each Rx
unit is assigned an IP. However, beware of using the IGMP broadcast protocol supported switch in the network environment and aware of the impact of broadcast on such a network. A pure network for IHD & its IGMP broadcasting is recommended.

You can go to the following website to download the utility.
https://www.dropbox.com/s/54bsszqpbt44tzx/Bonjour Browser.exe

1. Make sure the device cables are correctly and firmly attached.
2. Set your display device’s (TV, monitor, etc.) input source as HDMI.
3. Check the PC BIOS configuration about the video output setting.
4. Connect your computer to the HDMI Display DIRECTLY to check if the video signal gets through.
5. Slide the Rotary DIP Switch to the correct position.
6. EDID data is inappropriate. Apply EDID Copy to your display.
　 Please refer to the 4.1 EDID Configuration. (User’s Manual)
7. Please reboot or disconnect and connect again.
8. The system will disable the video output signal when it detects non-HDCP compliant display(s) on playing the
　 HDCP video source. All the connected output displays MUST be HDCP compliant while the video source is HDCP
　 compliant.