FAQs

Due to a different hardware design and PoE PSE port operation mode, we don’t suggest doing this kind of connection. Otherwise, it may damage the equipment.

Please use straight cable connects to your PoE device between PoE injector Hub and don’t use crossover RJ45 cable on your PoE network deployment.

Press the RESET button at front panel about 10 seconds and then release. The POE-1200P2 / POE-2400P4 will back to the factory default (Username / password: admin, IP: 192.168.0.100).

When power-surge occurs, the output voltage and current of transformer will increase or decrease on a sudden, which will burn out the device or shut it off. Either is not good to the device. With PoE, the electric power applied to remote device has been regulated by POE-100S. Therefore, even power surges, only POE-100 is affected. Through POE-100S, remote device still can get a stable power supply.

[Answer]
If you want to plug in 24 power devices and each of them consumed 30.8Watts, you will need 739.2Watts power budget, but HPOE-2400G offers power budget 460Watts only. Although HPOE-2400G supports IEEE 802.3af or IEEE 802.3at devices on each port, please don’t consume over than 460W power budget whatever how many PoE devices you plugged in.

[Answer]
If you want to plug in 12 power devices and each of them consumed 30.8Watts, you will need 369.6Watts power budget, but HPOE-1200G offers power budget 340Watts only. Although HPOE-1200G supports IEEE 802.3af or IEEE 802.3at devices on each port, please don’t consume over than 340W power budget whatever how many PoE devices you plugged in.