FAQs

Yes, you can connect the VC-230 to Planet VDSL2 Bridge and Switch devices below.
1. VC-231 / VC-234
2. VC-2400M / VC-820M

No, you can't. There are different hardware control codes inside these two versions. Each firmware can be used only for each model. Please double check the version before upgrading.

Yes, both support half bridge function. After login, just go to option "Advance > Other > Half Bridge" for enabling and selecting the interface.

A：No, we suggest not install at big building. Please refer to the following points for more understandings:
1.PL-702 must build in the same power loop, if the loop is different that can cause disconnect. Based on experience, the big buildings will have many different loops.
2.PL-702 maximum distance is 300M, if it is over that can cause signal failure and disconnect.
3.IF the powerline is old or broke and cause signal failure and disconnect.
4.The maximum number is 16 PCS for one PL-702 after another PL-702 at the same power loop.

A：Fast Ethernet is full-duplex, so a port can transmit and receive simultaneously. Consequently, if a Fast-Ethernet port is performing at its maximum throughput (e.g. sending and receiving) it can operate near it's theoretical maximum - 500Mbps.

ADN-4100 supports TCP/IP and Windows 7/Vista are also supporting IPv4 TCP/IP, therefore, it can be connected to these operating system. Furthermore, please refer to the step by step below, hope it would be useful assistance.

Please go through the control panel on windows 7/Vista and click the option of view network status and tasks of network and internet,


The screen will display network and sharing center and then the next searching for an option the change adapter settings (for vista is manage network connection) from the left hand,


Go through and then click the local area connection.

Please see the property of local area connection,


And then check the property of TCP/IP IPv4 option,


Set an IP address is the same subnet as ADN-4100 (the default IP of ADN-4100 is 192.168.1.1, please arrange your local ip address of PC from 192.168.1.2 to 192.168.1.254)


* ADN-4100 is with DHCP Server turned on by default, if your windows 7/Vista PC is connected by Ethernet cable with ADN-4100 and also set as DHCP client mode as well, it will obtain the IP address automatically.

Pleaes refer to the Power Point file (FAQ_EPL1000_EPN102VLAN.pps) for the setup steps. The EPL-1000 supports dedicated single VLAN or double VLAN. In this example, we use dedicated single VLAN for the setting.

In this example, there are using PLANET Switch FGSD-1022 as the switch example, for more about VLAN setup, please use the keywork "How to setup VLAN for different service" in our FAQ for more.