FAQs

For example of Cyber Cafe, because of the reason for saving more power, the owner usually switch the idle computers to sleeping mode. When some guests book the computers, the owner can wake up them by Ethernet in advance to save time. And the owner can also configure all the computers entering into sleeping mode automatically after the guests log off.

In order to guarantee the stability and better quality of network, so we would suggest the distance in 1.4 kilometer (profile17a) is the best for VC-231 / VC-234.

No, since VC-231 / VC234 and VC-201A / VC-204 with different VDSL2 chipset and hardware designed. The VC-231 / VC-234 cannot work with VC-201A / VC-204.

To connect with AP interface of MAP-2000’s RF2 interface, the WAP-8000 can set up Wireless AP-client mode as the Wireless client for the wireless connection. And at the mean time, please also disable the WAP-8000 "4-Address Headers" function (default is enabled) before making the wireless link.

The "4-address header" here is used for the purpose of optimize the link toward WAP-8000 to WAP-8000. And to act as AP-client mode and connect with non-WAP-8000 device, please disable the setting for the wireless connection.

The case of WNAP-7200 is designed more easy, more convenient and friendly installation. Please refer to below figure for cable installation.

Step1:
Please wind the RJ-45 cable around the pillar for one or two circle to fix cable, prevent loosing from LAN port connector.


Step2:
Please cover the Back Cover.

No, the frequency band of WNAP-7200 is 5GHz 11a ISM Band only; the range is 5.18~5.825GHz, so it can’t work with 2.4GHz band.

1.) Please set the WNRT-625v3 Operation Mode Configuration as the WISP Mode.


2.) Please set the type of WAN Port.


3.) Set the Wireless Setting / Site Survey function.


Choose the right SSID and security mode to Add the Profile.
Please check the Administrator function / status.