FAQs

※ Note: Strongly suggested to use the same model of device to configure the WDS connection, otherwise, the connection might be failed with different brands of wireless router.

Before configuring the WDS connection, the following steps are required:
1) Configure the two WNRT-617/627 (Terms of Router Devices in the following) with different IP address of the same IP subnet. (e.g. 192.168.1.1 as Site-1 & 192.168.1.2 as Site-2)
2) In each site of PC, manually assign a static IP address. (e.g. 192.168.1.100 as Site-1 & 192.168.1.200 as Site-2)
3) Disable the option of DHCP Server in Site-2. (“DHCP→ DHCP Settings→ DHCP Server”)

The procedure of WDS connection:
1) In Site-1 & Site-2, Go to “Wireless→ Wireless Settings”. Configure a fixed “Channel” in both sites; the channel should be the same. Then check the option “Enable WDS Bridging” as shown below:

2) Enter the SSID and BSSID (MAC address) of each other, or click “Survey” button to search the remote site.

3) Use command line tool to ping each other. If both sites can ping each other, then the connection is successful.

※ Configure an encryption key is strongly recommended, please be note that the encryption type and key must be the same and configured properly in both sites.

Regarding this detail descriptions, it is suggested to download the product FAQ.

Regarding this detail descriptions, it is suggested to download the product FAQ.

Hardware:
(1)The WNAP-C3220(V2) and the WNAP-C3220(V1) are adopted with different chipset solutions.
(2)The memory size of the WNAP-C3220(V2) has increased by twice, compared to the WNAP-C3220(V1).

Software:
(1)The WNAP-C3220(V2) has an added support of 802.1Q VLAN and Multiple-SSIDs.
(2)The WNAP-C3220(V2) increases the maximum supported wireless clients from 20 wireless STAs to 40 wireless STAs.
(3)The WNAP-C3220(V2) has an added support of scheduling reboot (self-healing) to enhance connection reliability.
(4)The WNAP-C3220(V2) has an added support of management software and Planet smart discovery.

1) Power off the WNAP-6305 first before connecting the external antenna to it.
2) Please use the extension cable (e.g. WL-SMA-0.6 or WL-SMA-6) with SMA-Type connector to WNAP-6305 and N connector to the outdoor N-Type antenna.
3) Power on the WNAP-6305, and then configure Antenna Switch to
“External” in the Basic Wireless Settings page.

First of all, please install “VAC.exe” (Virtual Audio Control) first on your computer. The software can be found in \Utility\ of the CD-ROM. After the driver is installed, please launch WPG utility. Click Menu icon, and select “Send Audio to Display” to Yes. After restarting WPG utility, you can have the audio via the audio jack of the WPG-200N.

No. The circuit design of WNAP-6305 is different from others since it has added an extra reset button on PoE Injector. Users MUST use the PoE Injector shipped with the WNAP-6305; Otherwise, it will cause damage to the WNAP-6305.