[GPL-8000] How to reset GPL-8000 If I forget the password

1. Use the RJ45 to DB9 console cable to connect the RJ45 side to GPL-8000’s port marked in red as shown in the picture below,

    and connect the DB9 connector to a PC.

2. Check your serial port number on the PC. Open device manager on the PC and you can see your serial port number

    (e.g. the PC is using COM1)

3. Install the “Putty” tool. It is a free software, which can be downloaded from the internet.

4. Open Putty Configuration for the setup. Select the “Serial” option, and input COM1 and 9600 (Please check your serial number first.).

5. Reboot GPL-800 and enter the Monitor mode. When you see the “RTC Test” message, press Ctrl + p to enter the Monitor mode.

àWhen you see the title “monitor”, it means you are in the Monitor mode and input the command of “dir”.