FAQs
FAQ Subject
- [ISW-514PTF(V3)] Please check the cable type of the connection from Industrial POE+ Switch (port 1 to port 4) at the other end. The cable should be an 8-wire UTP, Category 5e or above, and EIA568 standard within 100 meters. A cable with only 4-wire, short loop or over 100 meters will affect the power supply.
- [ISW-514PTF(V3)] lease check and assure the PoE powered device is fully complied with IEEE 802.3at standard.
The ENW-9740P must be connected to the 4-pin connector when users are going to use over 60W of PoE power. If users don’t use the 4-pin connector, it still can work and deliver 60W power. However, we still recommend to connect it to the 4-pin connector to make sure the system works well.
Please refer to the below table:
|
Model |
GSD-808HP |
|
|
PoE Budget |
130 Watts |
|
|
PoE Ability |
Number of Class 1 PD, <3.8W |
8 |
|
Number of Class 2 PD, <6.5W |
8 |
|
|
Number of Class 3 PD, <12.9W |
8 |
|
|
Number of Class 4 PD, 25W |
5 |
|
|
Input Power |
100~240V AC / 50-60Hz |
|
Please refer to following table for detail about difference between POE-E101 and
POE-E201.
|
Model |
POE-E201 |
POE-E101 |
|
Data Rate |
10/100/1000Mbps |
10/100Mbps |
|
Weight |
197g |
215g |
|
Power Requirement |
IEEE 802.3at compliant with voltage within 52V-56V DC |
IEEE 802.3af compliant with voltage within 44V-56V DC |
|
Power Consumption |
3.2Watts (maximum) |
1.9Watts (maximum) |
|
Standard Compliance |
IEEE 802.3ab 1000Base-T Gigabit Ethernet |
－ |
|
IEEE 802.3at High Power over Ethernet |
－ |
|
Model Name |
POE-151S& POE-152S |
POE-161S |
|
Output Voltage/Current |
Adjust by DIP switch: |
Adjust by DIP switch: DIP switch at 5V: 5VDC,4.5A max DIP switch at 12V: 12VDC, 2A max |
