FAQs

1. Please check the POE-150S is connect with an IEEE802.3af complied in-line device like POE-150, and check if the POE LED indicator at POE-150S is steady blink once attach to the 802.3af in-line power device. Then connect the DC plug cable to the device you would like to power on.

2. Please check the cable type of the connection from one end to the other end. The cable should be an 8-wire UTP, Category 5 or above, EIA568 cable within 100 meters. A cable with only 4-wire, short loop or over 100 meters, all will effect the power supply.

3. Please check the power requirement of the device you would like to power and check the label of the POE-150S if it meets the requirement. There are three models of POE-150S for different power output, DC 5V, DC 9 V and DC 12V.

4. Please check the specification of the powered device. If the device is over the specification of POE-150S, the LED indicator of POE-150S will blink instead of stead green. The maximum currents that POE-150S can supply are: 2A (5V DC), 1.3A (9V DC) and 1A (12V DC).

POE-150/150S will use 4-wire for data transmission (pair 1, 2, pair 3, 6) and 4-wire for power supply (pair 4, 5, pair 7, 8), thus Gigabit Ethernet device connect to POE-150/150S will not send data over the power wire and the transmit speed shall change to 100Mbps.

The default SNMP Trap community name is public. And it cannot be changed.

Please look the Power Usage table. If want to make the PSU works 100%, it only works between 0 ~ 40 Degree C. 50 Degree C will reduce 20% of Power Budget.

1. PLANET POE-150 and POE-150S is complied with IEEE802.3af in-line power standard. POE-150 can work with any IEEE802.3af complied PD (powered device) like Wireless AP, IP Phone, IP Camera. And POE-150S can work with any IEEE802.3af complied PSE (Power Sourcing Equipment) So, POE-150 and POE-150S can either work with each other like POE-100/100S or work separately co-work with any third party 802.3af devices.

2. POE-100 and POE-100S is proprietary Power-over-Ethernet device, it should runs in pair and can not operates separately. Nor it can work with POE-150/150S.

3. The splitter POE-150S will divided into three models for different DC power supply, i.e. POE-150S-5V, POE-150S-9V, POE-150S-12V for 5VDC, 9VDC and 12VDC power output.

FSD-808P can power 8 IEEE 802.3af PD devices. Each Port supports up to 15.4Watts. The total PoE Power Budget is 125Watts, must not over the PoE Power Budget, otherwise, it might cause the FSD-808P malfunction.

[Answer]
If you want to plug in 12 power devices and each of them consumed 30.8Watts, you will need 369.6Watts power budget, but HPOE-1200G offers power budget 340Watts only. Although HPOE-1200G supports IEEE 802.3af or IEEE 802.3at devices on each port, please don’t consume over than 340W power budget whatever how many PoE devices you plugged in.