FAQs

The IDL-2400 and IDL-4800 are both with two 1000Base-T Uplink interfaces; otherwise the IDL-2401 and IDL-4801 are both with one 1000Base-LX and one 1000Base-T Uplink interfaces.

With single-pair operation, SHDSL offers 192Kbps to 2.3Mbps. Data rates are defined in increments of 8Kbps. With dual-pair operation (4-wire mode), SHDSL offers 384Kbps to 4.6Mbps. Data rates are defined in increments of 16Kbps. The line rate on both pairs must be the same.

Step 1. Please refer to the topology below to install PL-702 x 2.

Step 2. Download and install Powerline Utility to Win8 PC (192.168.1.156).

PLANET Download Center: http://www.planet.com.tw/en/support/download.php?type1=102&model=48833&type=8184

Note: PL-802 and PL-702 is the same Utility.

Step 3. Reset PL-702 to default.

Step 4. Press the Pair button to connect the PL-702-B and PL-702-B.

Step 5. Check the PL-702-A that is connected with PL-702-B. You could open cmd.exe at ping the Win8 PC (192.168.1.156), and then ping Win8 PC (192.168.1.30).

Step 6. Open the Powerline Utility and press Scan to search all PLC at the same power loop.

Step 7. Set the name at each PL-702.

Step 8. Set Password for Each PL-702

Step 9. You could set Device password and network name that avoid hacking attacks.

Please refer to the Power point file FAQ_How to quick setup AnnexMforIDL.pps for the setup procedule.

The IDL supports G.992.5 ADSL 2 + Annex M, this will increase the Up Stream bandwidth of ADSL 2+ and Annex M supported ADSL 2+ CDE modem.

In this power point file, we use the ADE-3400 as the example, however, it will apply to all the PLANET ADSL 2+ & Annex M suported CPE modem Router.

No, you can't. The ADN-4000v2 equips with two dipped antennas inside the device.

There is a RESET BUTTON on the real panel of the device. To restore factory default settings, keep the device powered on and push a paper clip into the hole. Press down the button over 5 seconds and then release it. After resetting, the username and password will be restored to default settings admin and admin.

No, you can't. There are different hardware control codes inside these two versions. Each firmware can be used only for each model. Please double check the version before upgrading.